Zipper ZI-BSF1500 handleiding
Handleiding
Je bekijkt pagina 33 van 39
TROUBLESHOOTING
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at 33
ZI-BSF1500
• Allow the engine to cool down.
• Close the fuel supply valve.
• Remove the spark plug to prevent untrained persons from starting the machine.
• Clean the machine.
• Ensure that the machine is not stored near heat sources, naked flames or sparks.
• Loosen the steering device clamping lever and fold the steering device over.
• Cover the machine.
Short-term storage
• Start the machine at regular intervals (every 4 weeks) to dry out any accumulated moisture.
Longer storage
• Remove all fuel from the machine and store it properly.
OR
• Add fuel stabilizer to the full tank.
• Run the engine for at least 10 minutes to distribute the fuel stabilizer throughout the fuel
system.
• Stop the engine.
• Remove the spark plugs.
• Pour 5 ml oil through the spark plug hole.
• Close the spark plug hole with a rag and pull the starter handle a few times to lubricate the
combustion chamber.
• Replace the spark plug but do not connect it.
Improper storage can damage and destroy important components. Only store packed
or already unpacked parts under the intended ambient conditions!
16.4 Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or operating equipment in the residual waste.
If necessary, contact your local authorities for information regarding available
disposal options.
If you purchase a new machine or equivalent equipment from your specialist
dealer, p33-he is obliged in certain countries to dispose of your old machine
properly.
17 TROUBLESHOOTING
If you are unable to carry out the necessary repairs properly and/or do not have the required
training, always consult a specialist to solve the problem.
Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death.
Always stop the machine before carrying out troubleshooting work and secure
it against unintentional restarting.
Fault
Possible cause / remedy
engine does not start
• Check On-Off-switch and make sure it is positioned to "ON".
• Check fuel supply.
• Check engine oil level (a sensor prevents starting if oil level is too low).
• Make sure that the spark plug ignition cable is connected.
• Check spark plug.
• Check carburettor and air filter and make sure they are clean.
engine stops
• Check fuel supply.
• Check that the fuel tap is open.
• Check oil level.
• Check the condition of the air filter.
engine does not deliver
enough power
• Check fuel supply (If the fuel tap is open?)
• Check the condition of the air filter.
• Check throttle position.
NOTE
WARNING
Bekijk gratis de handleiding van Zipper ZI-BSF1500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zipper |
| Model | ZI-BSF1500 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9827 MB |
