Zipper ZI-BSF1500 handleiding
Handleiding
Je bekijkt pagina 31 van 39
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at 31
ZI-BSF1500
Changing the engine oil
• Remove the oil dipstick from the filler opening (1).
• Remove the oil drain plug (2) and allow the engine oil to drain
into a collection container.
• Close the oil drain plug (2).
• Fill the engine oil into the filler opening (1).
• Close the filler opening (1).
• Dispose of the used oil in an environmentally friendly manner.
16.2.4 Adjust / replace drive belt
Loose or worn V-belts reduce the efficiency of power transmission, result in poor compaction
performance and shorten the service life of the belt itself. Therefore, check the V-belt tension at
the prescribed intervals.
Tension
• Remove the belt guard.
• Loosen the 4 screws on the engine base.
• Loosen the locks nut (1, 3) on the tensioning and alignment bolts.
• Turn the tensioning screw (2)
- clockwise to increase the belt tension,
- counter clockwise to reduce the belt tension.
• Check the alignment of the pulleys, adjust with the alignment screw (4) if necessary.
NOTE: The belt tension is correct if you use your thumb to bend the belt in the middle by
10 mm.
• Tighten the nuts and bolts again
• Fit the belt guard.
Replace
• Remove the belt guard.
• Loosen the 4 screws on the engine base.
• Move the engine so that the drive belt becomes slack.
• Remove the drive belt and insert a new drive belt.
• Ensure that the running directions of the drive belt and the machine match. You will find an
arrow on the inside of the drive belt and on the machine.
• Tension the drive belt by moving the engine.
• Check the belt tension and adjust it if necessary, see above.
• Finally, retighten all nuts and bolts.
• Fit the belt guard.
16.2.5 Checking the clutch
Check the clutch at the same time as the V-belt. With the belt removed, visually check the outside
for seizure and the "V" groove for wear and damage. Clean the V-groove as required. If the clutch
shoe is worn, the power transmission becomes insufficient.
16.2.6 Change cutting teeth
Worn cutting teeth reduce the performance enormously. Check the condition of the cutting teeth
regularly and replace them as follows.
Risk of injury from sharp knives!
Always wear cut protection gloves when handling the cutting blade Risk of
injury!
WARNING
Bekijk gratis de handleiding van Zipper ZI-BSF1500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zipper |
| Model | ZI-BSF1500 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9827 MB |
