Zipper ZI-BSF1500 handleiding
Handleiding
Je bekijkt pagina 29 van 39
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at 29
ZI-BSF1500
• For large stumps, do not drop the cutting tool into the
stump hole. If a hole obstructs the work, fill it with chips or
change position.
• If you change position, lock the brake again before you start
milling.
15.4.4 Stop machine
• Press the handle down (1) to keep the milling tool off the
ground (2).
• Release the safety bar (3). The engine is switched off.
• Wait until the engine comes to a complete stop.
• Lower the milling tool so that it rests on the ground.
• Ensure that the brake is applied (4) to prevent
unintentional movement of the machine.
• Set the on/off switch to “OFF” (5).
• Allow the engine to cool down for at least 30 minutes
before transporting the machine.
• Close the fuel shut-off valve (6).
16 CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Risk of injury!
Always switch off the engine before cleaning, maintenance and repair work and
secure the machine against unintentional switching on by removing the spark plug.
Allow the engine to cool down.
Take particular care when working on the milling tool!
16.1 Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
• After each use, remove dust and dirt particles from the machine, especially from the
guards, air slots and engine housing and belt guard.
• Clean the machine with a damp cloth and, if necessary, some commercial detergent or
blow it out with compressed air at low pressure.
16.2 Maintenance
The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects
that could affect your safety must be repaired immediately!
• Before each operation, check the perfect condition of the safety devices.
• Regularly check the perfect and legible condition of the warning and safety labels of the
machine.
• Use only original spare parts recommended by the manufacturer.
16.2.1 Maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the technical limits:
Interval
Components
Action
before usage
• screws
• tighten if necessary or replace if lost
• oil level
• fuel level
• Check, top up if necessary.
• fuel system
• Check fuel lines, connections and hose
clamps for leaks and damage.
Repair/replace if necessary.
• brake system
• Check and adjust, if necessary.
• grinding tool
• Check blade sharpness; change if
necessary
• safety device
• Check function
• tyres
• Check mobility and tyre pressure
every 20 operating
hours
• bearing of the measuring shafts
• Lubricate with grease, type NLGI #2
• belt
• Check belt tension, tighten or replace if
necessary.
if necessary
• air filter
• spark plug
• clean or change
WARNI NG
NOTE
Bekijk gratis de handleiding van Zipper ZI-BSF1500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zipper |
| Model | ZI-BSF1500 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9827 MB |
