Zipper ZI-ASA550B handleiding
Handleiding
Je bekijkt pagina 22 van 32
OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at 22
ZI-ASA550B
• Check, whether the supply voltage and the frequency correspond to the specifications of
the machine.
NOTE
Deviation of the supply voltage and frequency!
A deviation from the value of the supply voltage of ±5 % is permissible.
A short-circuit fuse must be provided in the power supply system of the machine!
• Use a supply cable that fulfils the electrical requirements (e.g. H07RN, H05RN) and take the
required cross-section of the supply cable from a current carrying capacity table. Pay
attention to the measures for protection against mechanical damage.
• Make sure that the power supply is protected by a residual current circuit breaker.
• Connect the machine only to a properly grounded outlet.
• When using an extension cable, make sure that the dimension matches the connected
load of the machine. The connection power can be found in the technical data, the
correlation of cable cross-section and cable lengths can be found in the technical literature
or obtain information from a specialist electrician.
• A damaged cable must be replaced immediately.
15 OPERATION
Only operate the machine when it is in a perfect condition. Before each operation, a visual
inspection of the machine must be carried out. Safety devices and operating elements must be
checked carefully. Check screw connections for damage and tight fit. Check the extraction hose,
the filter bag and the chip bag for firm connection to the machine.
15.1 Connection to the wood working machine
NOTE
Do not work with the woodworking machine until the extraction system has reached full speed.
• Position the extraction system next to the woodworking machine so that the extraction
system does not obstruct you when working with the woodworking machine. Ensure that the
hoses are laid properly on the floor and mark unavoidable trip hazards in yellow and black.
• The distance between the extraction system and the woodworking machine should not
exceed 10 linear metres.
• The extraction hoses used must be made of flame-retardant material and be permanently
antistatic (or earthed on both sides) and comply with the relevant safety regulations.
• Connect the hose adapter of the extraction hose (1) to the
extraction connection of the woodworking machine.
• If necessary, use the hose adapters (2) to connect the
extraction hose to the woodworking machine.
15.2 Switch the machine on and off
Switch on
• Press the ON-OFF switch (1) to position “I”.
Switch off
• Press the ON-OFF switch (1) in position “0”.
Bekijk gratis de handleiding van Zipper ZI-ASA550B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zipper |
| Model | ZI-ASA550B |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 5809 MB |