Zelmer ZCF5601 handleiding
Handleiding
Je bekijkt pagina 14 van 76
14
PL
EN
4. Canopy
5. Motor
6. Controller set
7. Sleeve anchors
8. Mounting screws
9. Fan blade screws (6 pcs)
10. Hard wood fan blades (3 pcs)
MOUNTING BRACKET INSTALLATION
1. Select the installation method according to the structure of the ceiling (as shown in Figure 1 or 2), and use
appropriate fasteners.
2. Install the mounting bracket on the building structure as shown in the gure. The fan base mounting bracket
must support a load of 25 kg.
3. If you want to hang the fan on a ceiling without joists, you may need a hanger support bar.
HANGING PARTS ASSEMBLY
1. Loose the ball joint by removing the connecting pin and loosening the screws (Figure 3).
2. Insert the down rod through the canopy and joint cover and insert the motor wires through down rod, and then
secure ball joint back to down rod (Figure 4).
3. Insert down rod to hanger (Figure 5), line up hanger holes with down rod holes and insert bolt. Then insert pin
to end of bolt.
4. Finally secure down rod and hanger by tightening two screws (Figure 6).
HANGING THE FAN
1. Lift fan assembly onto mounting bracket (Figure 7).
2. Rotate the fan down rod by hand and ensure the notch of the ball joint is positioned on the stopper of mounting
bracket to prevent fan from rotating when in operation (Figure 8).
CONTROLLER KIT INSTALLATION AND POWER WIRING
WARNING: Disconnect the power by turning o the circuit breakers to the outlet box and associated wall
switch location before wiring power cables.
1. Install the receiver in the mounting bracket (Figure 9)
2. Connect the power input wires to the electrical power supply wires (Please contact a qualied electrician if you
don’t know how to do it).
Insert the Motor Input Connector and Power Input Connector into corresponding sockets on the Receiver (Figure
10)
3. Tuck all wires and the antenna into the canopy. Push the canopy upwards, lining up the keyholes on the bottom
with the screws on the hanger bracket. Twist the Canopy to lock it in place and then tighten the screws to secure
it. (Figure 11)
FAN BLADES INSTALLATION
1. Install the blade onto the motor with the provided screws (Figure 12).
2. Repeat with the remaining blades.
REMOTE CONTROLLER INSTRUCTIONS
1. LED indicator light
2. Appliance power o button
Bekijk gratis de handleiding van Zelmer ZCF5601, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zelmer |
| Model | ZCF5601 |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 5869 MB |
