Zeegma Zonder Wash handleiding

68 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 10 van 68
EN
7. To aach the extension hose (9, Fig. A), secure it to the exible sucon hose with spray
tube (1, Fig. A). Ensure that it is rmly secured. To remove the extension hose, pull it out.
CLEANING OF UPHOLSTERY AND CARPETS
Important! Aer each use of the appliance, make sure to rinse both the clean and dirty water
tanks, along with the sucon hose and the spray tube with nozzles.
1. To use the vacuum cleaner for cleaning upholstery and carpets, place the sponge lter
on the lter support (Fig. 4). Remove the HEPA lter before use (see: REMOVAL OF
DRY DIRT AND DEBRIS, step 7).
Important! When wet cleaning, always use sponge lter.
2.
Fill the clean water tank (10, Fig. A) with the prepared water and detergent soluon,
then aach it to the back of the appliance (Fig. 6). Ensure that it is securely connected.
Important! The amount of clean water in the tank should not exceed 4 litres. For beer
cleaning eciency, it is recommended to use warm water up to 40°C.
3. Connect the exible sucon hose to the outlet opening (7, Fig. A) and the spray tube to the
spray tube connecon (6, Fig. A). Ax an appropriate aachment (Fig. 9). Ensure it has been
installed correctly. To remove the aachment, press the release buon (a, Fig. 8) and pull.
REMOVAL OF WET DIRT
1.
Connect the power cord to the power source and switch on the appliance using the
main switch (3, Fig. A).
2. Use the vacuum cleaner to remove wet dirt from the surfaces to be cleaned. Repeat,
if necessary.
SURFACE SPRAYING
1. Connect the power cord to the power source.
2. To distribute the cleaning soluon, press the pump switch (2, Fig. A) and the trigger on
the handle of the exible sucon hose with spray tube (Fig. 10).
SIMULTANEOUS SPRAYING AND VACUUM CLEANING
1. Connect the power cord to the power source.
2.
Start the appliance with the main switch and press the pump switch. Then press the
trigger on the handle of the exible sucon hose with spray tube and secure it in posion
using the locking mechanism (Fig. 11).
Important! Use suitable detergents according to the manufacturer’s recommendaons for
the surface being cleaned.
Important! Always move the cleaning nozzle towards yourself along the surface being cleaned.
Important! If the tank overows, the oat obstructs the sucon opening, resulng in an
increased speed of the sucon turbine. Immediately switch o the appliance, disconnect it
from the power source, and empty the tank. Switch o the appliance by pressing the switch
(3, Fig. A) and the pump switch (2, Fig. A). To remove the clean water tank, simply pull it out.
If the appliance ps over with water inside, switch it oimmediately and disconnect it from
the power source to prevent motor damage.

Bekijk gratis de handleiding van Zeegma Zonder Wash, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkZeegma
ModelZonder Wash
CategorieStofzuiger
TaalNederlands
Grootte8034 MB