Zebra 8595 handleiding
Handleiding
Je bekijkt pagina 48 van 108
4 - 8 8585/8595 Vehicle-Mount Computer User Guide
In this state, the device continues to operate normally until the delay time (for example, 15 minutes) has
elapsed.
• If the ignition is triggered again during this time, the 8585 resumes normal operation.
• If, however, the delay time elapses, the operating system is shut down normally by the operating software
and the unit is automatically switched off (for example, after three minutes, or after a signal from the oper-
ating software).
Configuration with Zebra Config Program
The Zebra Config program must be installed for the automatic switch-off module to function correctly.
If the Zebra Config has not been started, the 8585 will carry out a hard shutdown once the delay time and shut-
down time set by the hardware (e.g. via MPCCOM.EXE) has elapsed. In this case, the operating system is not
shut down normally before the power is switched off. The current application is unable to save its data, and the
file system becomes increasingly unstable and inconsistent.
If the Zebra Config has been started, the program can recognize when the operating system needs to be shut
down. Firstly, the Windows message WM_QUERYENDSESSION is sent to all running applications to inform
them of the impending shutdown.
Now every application has to respond within the time that is set in the registry (see the Automatic Switch-off
Configuration Dialog on page A-6). If a response is not sent in the specified time, the application is forced
to quit.
If there are any open programs with unsaved changes, it may not be possible to automatically quit them (for
example, an unsaved document in WORDPAD.EXE, a program supplied with Windows). In this case
WORDPAD.EXE responds to the Windows message WM_QUERYENDSESSION with a user query to confirm
if the current file is to be saved. Applications that can be quit with the key combination [ALT] and [F4] (that is,
without a final user query) generally send the required response to the WM_QUERYENDSESSION message
and are not shutdown “hard”.
To ensure that vital data is always saved correctly, applications need to be able to properly respond to the
WM_QUERYENDSESSION message, that is, without user queries and within the set time period.
Further information on the Zebra Config program can be found in Appendix A: Zebra Config Program.
Bekijk gratis de handleiding van Zebra 8595, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zebra |
| Model | 8595 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13676 MB |
