Yamaha WaveRunner JetBlaster (2025) Handleiding (124 Pagina's)

Handleiding

Watercraft operation

38

To activate the cruise assist:

(1) Operate the throttle lever until the de-

sired engine speed is reached.

(2) When the engine speed reaches the de-

sired cruise assist setting, push the

“CRUISE/NO WAKE” switch. Once the

beeper sounds three times and the

cruise assist indicator is displayed, the

cruise assist is activated.

(3) When the cruise assist is activated, slow-

ly squeeze the throttle lever to keep it

squeezed further than the position at

which the cruise assist was set.

TIP

Check the multifunction information center to

make sure that the cruise assist is activated

before squeezing the throttle lever to the full

throttle position. If the cruise assist is not ac-

tivated, the engine will respond normally to

the throttle operation.

(4) Once the cruise assist is activated, push

the upper side of the “SPEED ADJUST”

switch to increase the set engine speed

or the lower side of the “SPEED AD-

JUST” switch to decrease the set engine

speed. The engine speed can be

changed in the range of the cruise assist

levels –5 to +5.

TIP

Because the cruise assist can only be set be-

tween engine speeds of approximately 4000

r/min and approximately 7000 r/min, the

cruise assist level cannot be adjusted to an

engine speed outside of this range.

To deactivate the cruise assist:

Relax your grip on the throttle lever past the

position at which the cruise assist was set.

The beeper sounds two times and the cruise

assist indicator disappears when the cruise

assist is deactivated.

1 Cruise assist indicator

2 Cruise assist level

1 “CRUISE/NO WAKE” switch

14.3v

RPM

x1000

km/h

Cruise Assist +5

21

1

1 “SPEED ADJUST” switch

1

UF5S70E0.book Page 38 Friday, October 11, 2024 9:51 AM

Bekijk gratis de handleiding van Yamaha WaveRunner JetBlaster (2025), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.