Workzone AB1600 handleiding

Handleiding

123456789101112131415161718/ 18

Afdrukken

Je bekijkt pagina 15 van 18

AFTER SALES SUPPORT

19

 1300 855 831

 support@scheppach.com.au

MODEL: AB1600 PRODUCT CODE: 53670 08/2017

AUS

AB1600 Maintenance/Electrical connection

Important: The waste oil must be disposed of in the appropriate collection point for

waste oil. Add new oil (approx. 25 ml) through the oil ller opening (6) until the oil

level reaches the required level. Tighten the hexagonal screw again. Re-check the

oil level after a short period of operation.

X. ELECTRICAL CONNECTION

The electrical motor installed is connected and ready for operation. The

connection complies with the applicable Australian standards.

The customer‘s mains connection as well as the extension cable used must

also comply with these regulations.

Damaged electrical connection cable

The insulation on electrical connection cables is often damaged.

This may have the following causes:

• Passage points, where connection cables are passed through windows or

doors.

• Kinks where the connection cable has been improperly fastened or routed.

• Places where the connection cables have been cut due to being driven over.

• Insulation damage due to being ripped out of the wall outlet.

• Cracks due to the insulation ageing.

Such damaged electrical connection cables must not be used and are life-threat-

ening due to the insulation damage. Check the electrical connection cables for

damage regularly. Make sure that the power is switched off before inspecting the

cable. Electrical connection cables must comply with the applicable Australian

standards and must be correctly marked. Only use connection cables with the

marking ''H07RN-F''.Replacement cables can only be tted by an approved and

certied electrician. If you are in any doubt please contact the help line at the foot

of this page.

AC motor

• The mains voltage must be 230 - 240 V~.

• Extension cables up to 25 m long must have a cross-section of 1.5 mm

2

.

• The mains connection must be protected with a delay action fuse of 16 A.

Connections and repairs of electrical equipment may only be carried out by an

electrician.

Please provide the following information in the event of any enquiries:

• Type of current for the motor

• Machine data - type plate

123456789101112131415161718/ 18

Bekijk gratis de handleiding van Workzone AB1600, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Niet gecategoriseerd