Williams Sound PPA T27 handleiding
Handleiding
Je bekijkt pagina 11 van 24
PPA T27
11
Receiver Model PPA R38 (optional) Instructions
The PPA R38 is a 17-channel receiver, operating on 72-76 MHz bandwidth.
1. Open the battery compartment. Slide the battery selection switch to the
correct position for the type of batteries that will be used. Use Alkaline for
non-rechargeable batteries. Use NiMH for rechargeable NiMH batteries only.
IMPORTANT: If the battery switch is not in the correct position, damage
may be caused to the unit.
Figure 6: Battery Compartment
ALKALINE/NiMH
BATTERY SWITCH
CAUTION: RECHARGE
ONLY NiMH BATTERIES
BATTERY REMOVAL
FABRIC STRIP
1. Install the AA batteries. Be sure to observe proper polarity (+/-). Damage
due to improper battery installation may void the warranty on the product.
The power button on top of the unit will flash when the batteries are getting
low; you may continue to use until the unit quits operating, then replace or
recharge the batteries.
2. Turn the unit on: press and hold the power button for three seconds. The
power button will illuminate green.
3. Select the desired operating channel/frequency on the transmitter. Up to
eight transmitters can operate simultaneously on dierent channels (see 8
channel mode in Table 4.
Bekijk gratis de handleiding van Williams Sound PPA T27, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Williams Sound |
| Model | PPA T27 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 967 MB |
