Wiesenfield WIE-PM-1500 handleiding
Handleiding
Je bekijkt pagina 8 van 35
EN
14
REPLACEMENT / REMOVAL OF THE DIE
To replace / remove the die, follow these steps:
• Disconnect the machine from the power supply.
• Unscrew the hopper and remove it from the machine.
• Remove the screws used to adjust the pressure
between the die and the rollers and remove the top
casing fastening screws. Remove the rollers.
• Use an Allen key to unscrew the die.
• To remove the die, rst attach the bracket using
the screws marked as 1 and 2 in the picture. Then
slowly screw in the screw No. 3, the die will start to
rise slightly.
• When re-installing the die into place and re-
assembling the device, proceed in the reverse order
as during disassembly.
ADJUSTMENT OF THE ROLLERS
The distance between the rollers and the die should be in
the range of 0.1-0.3 mm. The die should be able to rotate
freely under the rollers.
The adjustment is made with the screws marked in the
drawing below.
2
3
1
NOTE !: The screws should be identically tightened. If
they are tightened too much, one of the rollers may stop
turning and / or the roller may become deformed. Also,
do not increase the pressure of the rollers by tightening
the screws in the event that the die is clogged.
LUBRICATION
NOTE: Bearings should be lubricated with bearing grease
every 8 hours of operation
• Lubricate the bearing on the main shaft with a grease
gun as shown in the gure below.
EN
15
• Open the cover and lubricate the bearings.
• Ret the rollers in the reverse order as the
disassembly process.
OIL CHANGE
Change the oil after the rst 60 hours of operation. To do
this, you need to:
• Drain the waste oil from the reservoir. Place a waste
oil container under the machine and undo the screw
marked „b“ in the gure below. Wait for the oil to
drain out. Tighten the screw „b“.
NOTE: Waste oil must be disposed of in accordance
with local regulations.
• To pour fresh oil into the box, unscrew the oil ller
cap marked „a“ in the gure below. Pour in the oil
and close the ller cap.
a
b
• Lubricate the roller bearings.
To prepare the rollers for greasing, follow these steps:
• Unscrew and remove the hopper and the top casing.
• Remove the rollers.
• Undo the screws as shown in the gure below.
Before rst use, a new die should be polished and cleaned
using the following process:
a) Prepare
• 5kg our or saw dust,
c) Press the mixture 80 to 90 times through the die,
until the granules coming out of the chute meet the
quality requirements.
• 5 kg of ne sand (optional),
• 1,5 l of vegetable, used or dirty oil
b) Mix all ingredients in a bucket until to prepare a
mixture like in the photo below.
26.10.2022
Bekijk gratis de handleiding van Wiesenfield WIE-PM-1500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Wiesenfield |
| Model | WIE-PM-1500 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 21271 MB |
