Handleiding
Je bekijkt pagina 8 van 40
8
Installing the Air Filter
The filter should be installed behind the vented door, which is
located (depending on your model) along either the rear or left
interior wall near the top of the refrigerator compartment.
1. Remove the air filter from its packaging.
2. Lift open the vented door.
3. Snap the filter into place.
Air Filter Status Indicator
The filter comes with a status indicator, which should be activated
and installed at the same time the air filter is installed.
1. Place the indicator facedown on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator, until
the bubble pops to activate the indicator.
3. Lift open the vented air filter door. On some models, there are
notches behind the door.
On models with notches:
� Slide the indicator down into the notches, facing outward.
NOTE: The indicator will not easily slide into the notches if the
rear bubble has not been popped.
� Close the air filter door, and check that the indicator is visible
through the rectangular hole in the door.
On models without notches:
� Store the indicator in a visible place you will easily remember
either inside the refrigerator or elsewhere in your kitchen or
home.
Replacing the Air Filter
The disposable air filter should be replaced every 6 months, when
the status indicator has completely changed from white to red.
1. Remove the old air filter by squeezing in on the side tabs.
2. Remove the old status indicator.
3. Install the new air filter and status indicator using the
instructions in the previous sections.
REFRIGERATOR DOORS
Door and Handle Instructions
Depending on the width of your doorway, you may need to remove
the doors to move the refrigerator into your home. Also, the door
hinges are factory installed on the right-hand side. If you want the
door to open from the other direction, you must reverse the door
swing.
WARNING
Electrical Shock Hazard
Disconnect power before removing doors.
Failure to do so could result in death or electrical shock.
IMPORTANT:
� Before you begin, turn the refrigerator control off. Unplug
refrigerator or disconnect power. Remove food and any
adjustable door or utility bins from doors.
� If you are only removing and replacing the doors, see the
“Remove Doors and Hinges” and “Replace Doors and Hinges”
sections.
� If you choose to reverse the door swing, a Reversibility Kit,
which includes a new brand badge and hole plugs, is
available.
Tools Needed: 5/16" hex-head socket wrench, #2 Phillips
screwdriver, flat-blade screwdriver, 5/16" open-end wrench, flat 2"
putty knife
Remove Doors and Hinges
1. Unplug refrigerator or disconnect power.
2. Using a hex-head socket wrench, remove the three 5/16"
hex-head hinge screws from the top hinge and lift up to
remove the hinge.
NOTE: Provide additional support for the door while the
hinges are being moved. Do not depend on the door magnets
to hold the door in place while you are working.
Top Hinge Style 1
A. 5/16" Hex-head hinge
screws
C. Hinge pin
B. Top hinge D. Spacer
Top Hinge Style 2
A. 5/16" Hex-head hinge
screws
B. Top hinge
3. Lift the freezer door off of the center hinge and set it aside.
Bekijk gratis de handleiding van Whirlpool WRTX5328PB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Whirlpool |
| Model | WRTX5328PB |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 7620 MB |
