Handleiding
Je bekijkt pagina 11 van 40
11
Style 2 - Contour Door Models
Graphics follow these instructions.
Door Hinge
Hole Plug
Cabinet
Hinge Hole
Plug
Setscrew Door Stop
Screw
Shoulder
Screw
Washer
Dome Cap Dome Cap
Washer
Shoulder
Screw
Flat-Head
Handle
Screw
Door
Handle
Hole Plug
Cabinet
1. Remove the three dome caps and the screws from handle
side and move them to opposite side.
2. Using the three 5/16" hex-head hinge screws, insert two
screws halfway into the holes, leaving space to insert the
Center Hinge.
3. Slide the center hinge, from the right, onto the screws, insert
the third screw, and tighten all screws completely.
NOTE: Make sure the washers are in place on both the top
and bottom pins of the center hinge.
A. 5/16" Hex-head hinge screws B. Washers
4. Remove cabinet hinge hole plugs from the cabinet top and
move them to opposite side hinge holes as shown below.
A. Cabinet Hinge Hole Plugs
Freezer Door
1. Remove the freezer door handle. Using a 1/8" hex key, loosen
the setscrew located on the side of the handle. Pull the handle
straight out from the door. Keep all parts together.
A. Shoulder screw C. Flat-head handle screws
B. Setscrew
2. Remove the brand badge using the plastic tool (provided).
Replace it with the badge provided in the Reversibility Kit
located inside the crisper. For proper placement, see the
Brand Badge Placement template (the last page of this
manual).
NOTES:
� To avoid scratching the finish, do not use a sharp or
metallic object to pry the brand badge from the door.
� Rub a small amount of liquid dish soap over any adhesive
residue with your fingers. Rinse the door with warm water
and dry with a soft cloth.
3. Remove door stop. Move to opposite side of freezer door as
shown.
A. Door Handle Sealing Screws
4. Refer to image in Step 1. Install freezer handle again on
opposite side of the freezer door.
5. Tighten all screws. Set aside door until hinges and refrigerator
compartment door are in place.
Refrigerator Door
1. Remove the refrigerator door handle. Using a 1/8" hex key,
loosen the setscrew located on the side of the handle. Pull the
handle straight out from the door. Keep all parts together.
A. Flat-Head Handle Screw B. Set Screw
2. Remove door hinge hole plug from refrigerator door. Move to
opposite side hinge hole as shown below.
A. Door Hinge Hole Plug
3. Remove door handle hole plug and discard. Replace on
opposite side with the door handle hole plug provided in the
Reversibility Kit located in the crisper.
Bekijk gratis de handleiding van Whirlpool WRTX5328PB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Whirlpool |
| Model | WRTX5328PB |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 7620 MB |
