Handleiding
Je bekijkt pagina 24 van 56
24
PROBLEM POSSIBLE CAUSES SOLUTIONS
The water dispenser will
not operate properly
The refrigerator is not connected to a
water supply or the water supply shut-
off valve is not turned on
Connect the refrigerator to the water supply and turn
the water shut-off valve fully open.
There is a kink in the water source line A kink in the water line can reduce water ow from the
water dispenser and result in hollow or irregular shaped
ice. Straighten the water source line.
The refrigerator has just been installed Flush and ll the water system. See “Water Dispenser.”
The water pressure to the house is not
at or above 30 psi (207 kPa)
The water pressure to the house determines the ow
from the dispenser. See “Water Supply Requirements.”
A reverse osmosis water ltration
system is connected to your cold water
supply
A reverse osmosis water ltration system can decrease
water pressure. See “Water Supply Requirements.”
A water lter is installed on the
refrigerator
Remove lter and operate dispenser. If water ow
increases, the water lter may be clogged or incorrectly
installed. Replace lter or reinstall it correctly.
The refrigerator door is not closed
completely (on some models)
Close the door rmly. If it does not close completely,
see “The doors will not close completely.”
The refrigerator doors were recently
removed
Make sure the water dispenser wire/tube assembly has
been properly reconnected at the top of the refrigerator
door. See “Remove and Replace Refrigerator Doors and
Drawer Front.”
Water is leaking or dripping
from the dispenser system
NOTE: A few drops of water
after dispensing is normal.
The glass was not held under the
dispenser long enough
Hold the glass under the dispenser 2 to 3 seconds after
releasing the dispenser lever.
Water continues to drip
from the dispenser beyond
the rst few drops.
The refrigerator has just been installed Flushing the water system removes the air from the
lines which causes the water dispenser to drip. Flush
the water system. See “Water Dispenser.”
The water lter was recently changed Flushing the water system removes the air from the
lines which causes the water dispenser to drip. Flush
the water system. See “Water Dispenser.”
Water is leaking from the
back of the refrigerator
The water line connections were not
fully tightened
See “Connect the Water Supply.”
Recently removed the doors and did not
fully tighten water line connection
See “Remove and Replace Refrigerator Doors
andDrawerFront.”
Water from the
dispenser is warm
NOTE: Water from the
dispenser is only chilled to
50°F (10°C).
The refrigerator has just been installed Allow 24 hours after installation for the water supply to
cool completely.
A large amount of water was recently
dispensed
Allow 3 hours for the water supply to cool completely.
Water has not been recently dispensed The rst glass of water may not be cool. Discard the
rst glass of water dispensed.
The refrigerator is not connected to a
cold water pipe
Make sure the refrigerator is connected to a cold water
pipe. See “Water Supply Requirements.”
Bekijk gratis de handleiding van Whirlpool WRF560SFHW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Whirlpool |
| Model | WRF560SFHW |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 7778 MB |
