Whirlpool FFWDB 964489 BV SPT handleiding

Wasmachine

Whirlpool

33 pagina's

PDF beschikbaar

Handleiding

- Timer drying mode:

Press button “Cong. de Sec.” repeatedly to set timer drying

mode. After cycling through all the automatic drying levels,

continue pressing button “Cong. de Sec.” until the desired

time is displayed.

Values from 210 to 30 minutes are settable.

N.B.: always allow a cooling down period after drying before

opening the door.

5. USING THE CORRECT AMOUNT OF DETERGENT. Pull out

the tray and pour detergent into the relative compartments

as described in “Detergent dispenser”. This is only necessary

when using a wash only or a wash + dry programme.

6. DELAYING THE START OF A PROGRAMME. To set a

programme to start at a later time, see the section “Options

and Functions”.

7. STARTING A PROGRAMME.

Press the START/PAUSE button.

The machine will lock the door ( symbol OFF) and the drum

will start to rotate; the door will be unlocked ( symbol on)

and then locked again ( symbol OFF) as preparation phase

of each washing cycle. The “Clicking” noise is part of the door

locking mechanism. Water will enter the drum and start the

washing phase once the door is locked.

To change a programme while a cycle is in progress, press

START/PAUSE to pause the washer dryer (the START/ PAUSE

lamp ashes amber slowly); then select the required cycle and

press START/PAUSE again. To open the door while a cycle is in

progress, press START/PAUSE; the door may be opened if the

symbol lights. Press the START/PAUSE button again to

resume the programme from where it was paused.

8. CANCELLING A RUNNING PROGRAMME (IF NECESSARY)

Press and hold the button until the washer dryer stops.

If the water level and temperature are low enough, the door

unlocks and may be opened.

The door remains locked if there is water in the drum. To

unlock the door, switch the washer dryer on, select the

ENTRIFUGADO y DESAGÜE programme and turn the spin

function o by setting the spin speed to 0. The water is

emptied and the door unlocks at the end of the programme.

9. SWITCHING THE WASHER DRYER OFF AT THE END OF A

PROGRAMME.

At the end of the cycle, the message “END” is shown on the

display. The door can only be opened when the symbol

lights. Check that the door unlocked symbol is lit, then open

the door and take out the laundry.

Press to switch the washer dryer o. To save energy, if the

washer dryer is not switched o manually with the

button, it turns o automatically approximately 10 minutes

after the end of the programme.

Leave the door ajar to let the interior of the washer dryer dry.

Bekijk gratis de handleiding van Whirlpool FFWDB 964489 BV SPT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.