Westinghouse W14TCAC handleiding
Handleiding
Je bekijkt pagina 12 van 41
12
|
English
WARNING
Before inspecting, cleaning or servicing the unit, stop the motor, wait for all moving parts to stop, and
disconnect the tool from the power supply. Failure to follow these instructions can result in serious personal injury or property
damage.
WARNING
Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could
result in objects being thrown into your eyes resulting in possible serious injury.
WARNING
Use only authorized replacement parts. Use of any other parts can create a hazard or cause product dam-
age.
NOTICE
Periodically inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts, and
caps. Tighten all fasteners and caps. Do not operate this product until all missing or damaged parts are replaced. Please contact
customer service for assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents
and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, and grease.
WARNING
Do not let brake fluids, gasoline, petroleum-based products, or penetrating oils contact plastic parts.
Chemicals can damage, weaken, or destroy plastic which can result in serious personal injury.
CAUTION
Always clean the tiller after each use. Failure to clean the tool can result in damage or result in poor per-
formance.
CAUTION
Never use a water hose to clean the tiller.
Clean beneath the tine guard and motor housing with a scrubbing brush and a soft cloth, damp with a mild soap and water mixture.
To remove soil and debris from the transmission and tines, use a brush or a damp cloth.
Clean the vents on the motor housing and remove any remaining grass or dirt.
After cleaning the tool, dry the tines and shaft and apply a light lubrication oil to prevent rust.
REMOVING THE TINES
Worn tines result in poor performance and can overload the motor.
WARNING
Always wear protective gloves when performing maintenance on the tines.
Check the tines before each use. Sharpen or replace the tine assembly as necessary.
1. Remove the two nuts and screws from the tine shaft.
2. Remove the tine assembly from the tine shaft.
3. To install new tines, attach the tine assembly to the tine shaft and secure with the screws and nuts.
STORING THE TOOL
z Wipe the tool with a clean dry cloth.
z Inspect all nuts, bolts, knobs, screws, and fasteners for tightness.
z Inspect moving parts for damage, breakage, and wear. Have repairs made on any damaged or missing parts.
z Store the tool indoors in a clean, dry place out of the reach of children.
z Do not store near corrosive materials such as fertilizer or rock salt.
MAINTENANCE
Bekijk gratis de handleiding van Westinghouse W14TCAC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Westinghouse |
| Model | W14TCAC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3821 MB |
