Westinghouse HW120A16 handleiding
Handleiding
Je bekijkt pagina 11 van 80
Installation
WARNING
Ÿ If a leak occurs, it is recommended to
install a drain pan or other waterproof
protection under the water heater.
Ÿ Keep the area around the water heater
clean. When the dust collects on the
flame, the sensor will turn off the error
code.
Ÿ Make sure the equipment has adequate
combustion air and proper ventilation.
Failure to do so may result in carbon
monoxide poisoning or death.
Ÿ Place the equipment for easy repair and
maintenance.
Ÿ Failure to follow these warnings can
result in serious personal injury, death
and/or property damage.
WARNING
Ÿ Installation and repair must be performed
by a qualified installer (for example, a
licensed plumber or gas fitter) or the
warranty will be void.
Ÿ Due to safety issues, the manufacturer
does not recommend installing the water
heater in the attic.
Ÿ The installer (authorized professional) is
responsible for properly installing the
water heater and complying with all
national, state/provincial and local
regulations.
Ÿ The manufacturer does not recommend
installing the water heater in a pit or
location where gas and water may
accumulate.
Ÿ Do not point the vent to any operating
window, door or opening to the building.
Ÿ Do not install any air debris (such as a
dryer) that could cause debris to get
trapped in the combustion chamber
unless the system is directly ventilated.
Ÿ Do not install the unit in water, debris or
flammable vapors that may enter the flue
terminal or intake line.
NOTICE
Ÿ The warranty does not cover damage
caused by water quality.
Ÿ Although the water heater is designed to
operate with minimal sound, the
manufacturer does not recommend
installing the unit on a wall close to the
bedroom or in a room for quiet study or
meditation.
Ÿ When the water heater is installed in a
beauty salon, dry cleaner or in the air,
there is such a chemical. Whenever any
other location, the manufacturer
recommends direct venting. Certain
chemicals used in beauty salons or dry
cleaners may affect the flame sensor. In
this case underneath, the water heater
may not work properly.
Ÿ Well water must be disposed of.
Ÿ Place the heater near the drain and the
water will not damage the surrounding
area. As with any water heating device,
there is a real possibility of leakage at
certain times during the life of the
product. The manufacturer is not
responsible for any water damage that
may occur. If you install a drain pan under
the unit, make sure it does not restrict the
flow of combustion air.
Ÿ This water heater can only use potable
water. Do not introduce pool or hot spring
water or any chemically treated water
into the water heater.
Ÿ For all other types of applications, the
water hardness level for single- family
applications should not exceed 7 grains
per gallon (120 ppm) or 4 grains (70 ppm)
per gallon. The hardness of the water can
cause scaling and can affect/damage the
water heater. Hard scale must be avoided
or controlled by proper water treatment.
Ÿ The pH of the water must be between 6.5
and 8.5.
11
Bekijk gratis de handleiding van Westinghouse HW120A16, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Westinghouse |
| Model | HW120A16 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7198 MB |
