Warmup VLo Ultra-12 handleiding
Handleiding
Je bekijkt pagina 15 van 32
15
Step 4 - Lay the pipe
•Ensurethereisexcessowand
return pipe at the manifold
location which can be cut later
after the pipe has been laid.
• Plan the circuit layout ensuring
thattheowandreturnpipes
can connect from the manifold
to their respective heated area
without crossing each other.
1
3
If the project has been supplied with a set of working drawings, follow
the provided pipe layout. Ensure each circuits details are recorded in the
commissioning log provided in the Warmup manifolds installation manual.
• Attach pipe bend supports to
hold the pipe at a 90° angle as
itenterstheoor.Positionthe
support so that the pipe rises
straight to the manifold with
approximately half the support
withintheoor.
• Leave a 150mm space the width
of the manifold arms to allow for
the curve pipe supports.
4
• Before installing the pipework
ensure the adhesive has cured
where used. Sweep or vacuum
the panels to clear any debris.
2
Feed pipes normally go through doorways but to minimise
congestion, pipes can be fed through walls. Ensure holes drilled
inthewallarebelowoorlevelandthepipeisprotectedwitha
conduit.
Bekijk gratis de handleiding van Warmup VLo Ultra-12, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Warmup |
| Model | VLo Ultra-12 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8703 MB |
