Warmup VLo Econna-12 handleiding
Handleiding
Je bekijkt pagina 4 van 28
4
Please also read the full instructions that follow this section.
Installation summary
• If the oor void is not accessible,
steps 3 - 9 will need to be
completed room-by-room,
beginning from the room furthest
from the manifold.
• Drill a 12.5 mm hole in this rst
panel at a 20° angle where the
ow pipe needs to drop into the
joist space.
• Feed the pipe through the hole
through to the manifold location,
notching/drilling the joists as
required in line with building
regulations.
• Secure the panels together using
a D4 adhesive on BOTH sides
of the tongue and groove and
t together. The panels should
then be glued and screwed to the
joists.
• If the oor void is accessible
from below, steps 3 - 9 can be
completed for the whole oor
deck, no access panels will be
required.
• Lay the rst panel in the corner
of the room, leaving a minimum
10 mm gap between the end
and edge of the panel and the
walls. The two groove edges of
the panel should be placed in the
corner. The opposite end of the
panel must sit on the centre line
of a joist.
• Apply a 6mm bead of D4 adhesive
to the joists.
• Lay the panels in a run, ensuring
the end of each panel is on the
centre line of a joist.
• Panels should be laid in a
brickbond pattern with a min.
overlap of 800 mm.
• Ensure that each row of panels
has a group of return loops at
each end.
1 2
3 4
5 6
10 mm
10 mm
Bekijk gratis de handleiding van Warmup VLo Econna-12, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Warmup |
| Model | VLo Econna-12 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6226 MB |
