Warmup Tectora handleiding
Handleiding
Je bekijkt pagina 7 van 28
7
Important installation information
Perform a site inspection. You will need to conrm that all
measurements and other requirements on site match your
working drawings. Ensure that all areas are correctly prepared, dry
and protected from weather.
Inspect the site for possible hazards that could damage the
Warmup pipe, such as nails, staples, materials or tools.
Ensure that insulation is installed between the joist in line with
building regulations. Joists must be level and even, clear of debris
and without any surface deviations such as knots or nails.
Safety gloves must be worn. While all eorts have been made to
ensure there no burrs or sharp edges, the aluminium diuser
plates may have some sharp edges.
Dust particles may become airborne when cutting wood or
insulation products. Therefore please follow relevant health and
safety rules when cutting the diuser plates or insulation by using
a mask, goggles, gloves and ensuring adequate ventilation.
Use a pipe cutter designed for plastic pipe ensuring that there
are no burrs on the pipe ends. It is important to achieve
a clean cut.
Do not pull pipe from the coil while it is sitting at. It must be
unwound from the coil, rotating the coil as the pipe is pulled from
the inside.
Do not force the pipe into bends. It is easier to lay the pipe with
a large radius and then gently pull the pipe to the required bend.
The minimum bending radius is 5 times the diameter of the pipe.
Do not kink the pipe. Excessive bending of the pipe can cause it to
kink, where this occurs ow may be obstructed or reduced. Kinked
pipe must be repaired or replaced. To repair a kink, straighten
the pipe and simply heat the area with a hot air gun until the kink
disappears.
Before installing the oor nish, its suitability for use with
underoor heating and its maximum operating temperature
should be checked against required operating conditions.
Underoor heating performs the most eciently with conductive,
low resistance oor nishes such as stone and tiles. Consideration
should be given to the thermal resistance and temperature limits
of the chosen oor covering and its impact on the system heat
output.
Bekijk gratis de handleiding van Warmup Tectora, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Warmup |
| Model | Tectora |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8419 MB |
