Warmup Foil Heater handleiding
Handleiding
Je bekijkt pagina 4 van 42
4
Please also read the full instructions that follow this section.
Installation summary
• The suboor must be
pre-insulated unless it is an
intermediate oor. Ensure the
suboor is prepared to an SR1
surface regularity. The suboor
must be smooth, dry, frost-free,
solid, suitably weight-bearing and
dimensionally stable.
• Test the resistance of the heating
mat ensuring it is within the
range set out in the Reference
Resistance Band table.
• Install Warmup Insulated
Underlay referring to its
instructions� Insulation MUST
be used below the Warmup Foil
Heater and MUST be minimum
6 mm thick and ≤ 500kPa
compressive strength�
• Make electrical provision for the
system (30 mA RCD, overcurrent
protection, 35 mm deep electrical
back boxes, trunking).
1 2
6
3
4
SR1
2 m < 3 mm
• Cut a section in the underlay for
the coldtail joint and coldtail so
that it sits at the same height as
the heater�
• Secure the coldtail using tabs of
electrical tape as necessary�
5
• Begin laying the heating mat,
cutting the mat and turning/
rotating the mat to t the oor
area�
• Any exposed sections of heating
cable MUST be bridged with the
aluminium foil strips provided.
This is required to maintain the
earth continuity of the mat�
Bekijk gratis de handleiding van Warmup Foil Heater, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Warmup |
| Model | Foil Heater |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11009 MB |
