Wachendorff WDGA 58F handleiding
Handleiding
Je bekijkt pagina 35 van 79
Technical Manual
WDGA with EtherNet/IP
4 - EtherNet/IP
© Wachendorff Automation GmbH & Co. KG
27
19
Preset Value
UDINT
RW
The preset value is subject to
scaling, it can be reset again and
again.
Default: 0
If the preset is executed, then
the following applies to the
offset:
Offset value (attr. 51) = Preset
value - Position value
21
Position State
register
USINT
R
The Position State Register
serves as a software defined
limit switch.
Bit 0 = 1 Out of Range
Bit 1 = 1 Range overflow
Bit 2 = 1 Range underflow
22
Position Low Limit
DINT
RW
Lower limit of the end position. Is
compared with the position
value. If the value falls below the
limit, the status can be read out
via attribute 21.
23
Position High Limit
DINT
RW
Upper limit of the end position. Is
compared with the position
value; if exceeded, the status
can be read out via attribute 21.
24
Velocity value
DINT
R
See: Table 4.6
25
Velocity format
ENGUINT
RW
See: Table 4.9Table 4.6
26
Velocity resolution
UDINT
RW
The resolution of the velocity
value is defined in steps of
0.01mm/s.
41
Operating Status
USINT
R
Indicates the operating status of
the encoder:
Bit 0: Direction
False (0) = Increasing
True (1) = Decreasing
Bit 1: Scaling
False (0) = Off
True (1) = ON
42
Physical Resolution
Span
UDINT
R
The maximum number of steps
per revolution is shown here.
= 10000h
43
Number of spans
UINT
R
Specifies how many revolutions
can be measured.
ST = 1
MT = FFFFh
Bekijk gratis de handleiding van Wachendorff WDGA 58F, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Wachendorff |
| Model | WDGA 58F |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11849 MB |
