Vulcan C24DA10 handleiding
Handleiding
Je bekijkt pagina 36 van 65
Spark Ignition Control Test
The ignition control module and ignition control module transformer are located in the electronics enclosure behind
the generator base front cover.
PREVIOUS PRODUCTION SHOWN IN Fig. 66
Fig. 66
1. Check for earth ground.
PREVIOUS PRODUCTION SHOWN IN Fig. 67
Fig. 67
2. Check to ensure that all electrical terminal connections on the ignition control module and the igniter are clean
and tight.
3. Verify that the ignition control module and the igniter have good ground wire connections. The igniter mounting
bracket should have good metal to metal contact to its mounting surface.
4. Turn the main power switch on. Make sure LLCO light is on.
5. Check for 24VAC output on the ignition control module transformer.
C24GA AND C24DA SERIES CONVECTION STEAMER - SERVICE PROCEDURES AND ADJUSTMENTS
F35425 Rev. E (0119) Page 36 of 65
Bekijk gratis de handleiding van Vulcan C24DA10, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vulcan |
| Model | C24DA10 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16865 MB |
