Vonroc SG504CA handleiding
Handleiding
Je bekijkt pagina 6 van 76
6
EN
WWW.VONROC.COM
important cautionary measure will void the
guarantee.
2. Clean the container thoroughly with the thinner
solvent you have used.
3. Put a little thinner solvent into the container and
spray until only clean, thinner solvent exits the
spray gun. Be aware of your surroundings when
spraying outside, wind can cause un-intentional
spraying of your not covered surroundings.
4. Clean the nozzle and remove all remaining dirt
or paint.
- Remove the nozzle (4), nozzle needle (5) ,
Needle spring (6) like explained in chapter
replacing the nozzle.
- Clean all the nozzle parts thoroughly, do not let
them soak in any cleaning detergent or water.
5. If the cylinder hole becomes blocked, use a
suitable cylinder cleaning needle.
6. Clean the outside of the machine
- Clean plastic parts with a soft, clean cloth,
preferably after each use.
Do not use aggressive cleansers (solvents or
abrasive cleansers), or an abrasive sponge or sharp
objects. Do not put or immerse product in water or
any other liquid.
Always read the precautions laid down by the
paint/varnish manufacturer.
• Do not use liquids containing abrasive
substances such as red lead oxide, glazes,
caustic, and alkaline substances. The use of
these liquids can lead to excessive wear or
corrosion to the pump assembly.
Always disconnect the air tool from the
main power supply before carrying out any
maintenance work.
Clean the air tool casings regularly with a soft
cloth, preferably after each use. Make sure that
the openings are free of dust and dirt. Remove
very persistent dirt using a soft cloth moistened
with soapsuds. Do not use any solvents such as
gasoline, alcohol, ammonia, etc. Chemicals such as
these will damage the synthetic components.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by
company either expressed or implied. There are
no other warranties expressed or implied which
extend beyond the face hereof, herein, including
the implied warranties of merchantability and
fi tness for a particular purpose. In no event
shall VONROC be liable for any incidental or
consequential damages. The dealers remedies
shall be limited to repair or replacement of
nonconforming units or parts.
The product and the user manual are subject to
change. Specifi cations can be changed without
further notice.
Bekijk gratis de handleiding van Vonroc SG504CA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vonroc |
| Model | SG504CA |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7895 MB |
