Vonroc SG504CA handleiding
Handleiding
Je bekijkt pagina 4 van 76
4
EN
WWW.VONROC.COM
adapters. The appliance is not designed for
continuous operation.
TECHNICAL SPECIFICATIONS
Model No. SG504CA
Operating pressure 2 - 8bar
Paint container capacity 600 ml
Optimal operating pressure 3.5 bar
Paint nozzle size 1.4mm, 1.7mm, 2.0mm
Compressed air quality
Cleansed, oil-free and free of
condensation
Air requirement 100 L/min
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
1. Spray gun
2. Connector
3. Trigger
4. Nozzle
5. Needle
6. Needle spring
7. Filter
8. Viscosity cup
9. Nozzle exchange tool
10. Cleaning brush
11. Tefl on/ PFTE tape
12. Fluid adjustment knob
13. Flow control valve
14. Pressure regulation valve
15. Paint cup
3. ASSEMBLY
For Household use only.
Connecting the spray gun (Fig. A)
• Insert the connector (2) of the spray gun (1)
into the quick coupler on the air hose. When
pushing, the connector clicks into place to
secure the spray gun (1).
Disconnecting the spray gun (Fig. A)
When releasing the quick coupler, be sure to hold
the coupling to protect yourself from injury from
the rebounding hose.
• Pull back the sleeve on the quick coupler and
remove the tool.
Warning: Make sure to disconnect the spray gun
from the air supply before adjusting or maintaining
the spray gun.
Replacing the fi lter (Fig. B)
Replacement fi lters are not included, these can be
ordered separately. (Article number: SG812AA).
• Unscrew the paint cup (15) from the spray gun (1).
• Take out the fi lter (7).
• Put in a new fi lter (7).
• Put the fi lter back into the spray gun (1) and
screw in and tighten the paint cup (15).
4. OPERATION
PAINT PREPARATION
Check/test the viscosity of the to be sprayed
material. Using the viscosity cup (8).
Step 2: Preparing the spray surface
• Cover the area around the to be sprayed area
thoroughly and over a wide area. Any surface
that is not covered properly can unintentionally
be sprayed.
Warning! Be aware of your surroundings when
spraying outside, wind can cause unintentional
spraying of your not covered surroundings
• The spray surface needs to be clean, dry, and
free from grease or dust.
• Polished surfaces should be lightly sanded, and
the sanding dust removed.
Step 3: Filling the paint container
• Remove the paint cup (15) from the Spray unit.
• Fill the container with to be sprayed material to
a maximum of 600ml.
Step 4: Test and adjust the spray jet effect, spray
volume and spray fl ow. (Fig. A and Fig. B)
Note: Before starting to spray the work surface, it
is advisable to make an initial test by spraying a
small area on scrap material.
Tip! With low-viscosity use the smaller nozzle and
with high-viscosity use the bigger nozzle.
Bekijk gratis de handleiding van Vonroc SG504CA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vonroc |
| Model | SG504CA |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7895 MB |
