Vonroc OT504DC handleiding
Handleiding
Je bekijkt pagina 9 van 108
EN
9
WWW.VONROC.COM
The charger has 2 LED indicators (12) which indi-
cate
the status of the charging process:
Red LED Status Green LED status Charger status
Off Off No power
Off On
Standby mode:
- No battery is
inserted or,
- Battery inserted
but charging has
finished
On Off
Battery charging in
progress
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the charg-
er plug from the outlet and remove the battery from
the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Removing and mounting accessories (Fig. B, C)
Worn or damaged accessories must be
replaced immediately.
Only use sharp and undamaged accessories.
• Release the quick change lever (4) and slide the
accessory forward to remove from the holder.
• Slide the accessory in the holder and fasten the
quick change lever (4).
The sanding pad and the sanding paper must be
used for sanding applications
Mounting the dust extraction (Fig. C)
The dust extraction piece can be used to connect
the machine to a vacuum cleaner when sanding.
Dust will be extracted and your work area stays
cleaner.
The dust extraction adapter can only be used in
combination with the sanding pad (8).
To install the dust extraction adapter:
1. If not done yet, remove the accessories from
the machine.
2. Assemble the dust extraction adapter (7) like
shown in Fig. C.
3. Mount the dust extraction adapter (7) by tighte-
ning the screw.
4. Assemble the sanding pad like instructed in
previous chapter.
5. Connect a vacuum cleaner to the adapter.
4. OPERATION
Switching on and off (Fig. A)
• To switch on the machine, slide the on/off
switch (1) to the front.
• To switch off the machine, slide the on/off
switch (1) to the rear.
Setting the speed (Fig. A)
The speed adjustment wheel is used for setting the
speed. The speed adjustment wheel can be set to 6
positions. The ideal speed depends on the applica-
tion and on the material to be worked.
Do not set the speed during use.
• Turn the speed adjustment wheel (13) to the
required position.
Hints for optimum use
• Clamp the workpiece. Use a clamping device for
small workpieces.
• Draw a line to define the direction in which to
guide the accessory.
• Firmly hold the machine by the grip.
• Switch on the machine.
• Wait until the machine has reached full speed.
• Place the accessory on the workpiece.
• Slowly move the machine along the pre-drawn
line, firmly pressing the accessory against the
workpiece.
• Do not apply too much pressure on the machine.
Let the machine do the work.
• Switch off the machine and wait for the machine
to come to a complete standstill before putting
the machine down.
Bekijk gratis de handleiding van Vonroc OT504DC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vonroc |
| Model | OT504DC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13148 MB |
