Vonroc CT504CA handleiding
Handleiding
Je bekijkt pagina 5 van 56
EN
5
WWW.VONROC.COM
5. MAINTENANCE
Make sure that the machine is not live when
carrying out maintenance work on the motor. This
machine has been designed to operate over a long
period of time with a minimum of maintenance.
Continued satisfactory operation depends upon
proper machine care and regular cleaning.
Malfunction
In case a staple or nail is jammed in the tool, follow
the procedure below:
• Remove the air hose from the connector (7).
• Place the tool down on its side.
• Press the cartridge shaft release lever, pull the
cartridge shaft (3) backward and unload the
staples or nails strip.
• Remove the clogged staple/nail from the
cartridge.
• Reload the staples/nails and push the cartridge
shaft back in place until it clicks.
• Test the machine on a piece of scrap.
Operating tips:
• WARNING! Nails or staples must be driven
straight into the material. Do not tilt the machi-
ne during operation.
• Do not operate the machine without staples or
nails. This will shorten the service life of the
machine.
• Should nails or staples jam frequently, have ma-
chine serviced by an authorized service centre.
• If the head of the nails or staples remains above
the workpiece surface, press the machine head
firmly against the workpiece and try again. If
there is no improvement in the rework, the cho-
sen material may not be suitable for the tool.
Cleaning
Regularly clean the device’s casing with a soft
cloth, preferably after each use. Keep the fan slits
free of dust and dirt. Remove tough dirt using a
soft cloth, dampened with soapy water. Do not use
solvents such as benzene, alcohol, ammonia, etc.,
which might damage the plastic parts.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by compa-
ny either expressed or implied. There are no other
warranties expressed or implied which extend
beyond the face hereof, herein, including the im-
plied warranties of merchantability and fitness for
a particular purpose. In no event shall VONROC be
liable for any incidental or consequential damages.
The dealers remedies shall be limited to repair or
replacement of nonconforming units or parts.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
Bekijk gratis de handleiding van Vonroc CT504CA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vonroc |
| Model | CT504CA |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5938 MB |
