Vivolink VLVWIP2000-ENC handleiding
Handleiding
Je bekijkt pagina 27 van 34
Step 4: According to the IP address of the Encoder/Decoder found through
the bonjour protocol checking tool, input “http://IP:PORT/?action=stream” into
the web browser on PC. The MJPEG Substream will be displayed with the
default resolution, as shown in the figure below.
21 / 27
Step 5: Change the resolution of the obtained Encoder/Decoder IP address
in the following format.
http://IP:PORT/?action=stream&w=x&h=x&fps=x&bw=x&as=x&mq=x
▪ WIDTH: [Optional] image width. In pixels. ‘x’ means no change.
Default is 640.
▪ HEIGHT: [Optional] image height. In pixels. ‘x’ means no change.
Default is 360.
▪ FRAMERATE: [Optional] frame rate of sub-stream.
Unit: fps (frame per second). ‘x’ means no change. Default is 30.
▪ BW: [Optional] maximum bandwidth of sub-stream traffic.
Unit: Kbps (Kbits per second). ‘x’ means no change. Default is 8000 (8Mbps).
▪ AS: [Optional] aspect ratio configuration. ‘x’ means no change. Default is 0.
▪ 0: extend to what “WIDTH” and “HEIGHT” configured
▪ 1: [A1 only] keep original aspect ratio and place in the center of output
(letterboxing or pillarboxing)
▪ MINQ: [Optional] minimum image quality number. Range: 10, 20, …, 90,
100, higher setting means better image quality. ‘x’ means no change. Default
value is 10. Limit driver auto bandwidth control’s minimum quality number.
If quality lower then MINQ value, the driver will drop frame by returning 0
size file.
JPEG2000 AVoIP Encoder and Decoder
Bekijk gratis de handleiding van Vivolink VLVWIP2000-ENC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vivolink |
| Model | VLVWIP2000-ENC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2985 MB |
