Vivolink VLVWIP2000-DEC handleiding
Handleiding
Je bekijkt pagina 17 van 34
11 / 27
3
LINK LED
(Green)
4
5 CH SELECT
LED screen
Used to set Decoder ID and other settings.
6
USB 1.1 DEVICE
Connect to USB 1.1 devices, such as Keyboard or Mouse.
7
USB 2.0 DEVICE
Connect to USB 2.0 devices, such as USB flash disk or USB
Camera.
8 IR OUT
IR signal output port. The IR level can be set to 5V or 12V
(default) through the panel buttons.
9
IR IN
IR signal input port. The IR level can be set to 5V or 12V
(default) through the panel buttons.
RELAYS I
DIGITAL IO
10
Shows the selected Encoder ID as default. Displays the
corresponding options of configuration functions during setting
Decoder configurations.
Connection status LED.
▪ Light on: Encoder and Decoder are connected through the
LAN(POE)/FIBER ports, and there is video signal transmitted
from the Encoder.
▪ Light flashes: Encoder and Decoder are connected through the
LAN(POE)/FIBER ports, but there is no video signal transmitted
from the Encoder.
▪ Light off: Encoder and Decoder are not connected through the
LAN(POE)/FIBER ports.
VCC: Power output (12V or 5V configurable), maximum to
12V@50mA, 5V@ 100mA loading. The default output is 12V.
RELAYS: 2 channel low-voltage relay ports, each group is
independent and isolated, maximum to 1A 30VDC loading.
Contacts are disconnected by default.
DIGITAL IO: 2 channel GPIO ports, for digital level signal
output control or input detection (up to 12V level detection).
The output control mode (default mode, low level as default
output) or input detection mode is configurable. The DIGITAL
IO internal pull-up voltage follows the VCC.
Output control mode:
a. The maximum withstand sink current is 50mA when
outputting low level.
b. When VCC is 5V and high level is output, the maximum
current driving capacity is 2mA.
c. When VCC is 12V and high level is output, the maximum
current driving capacity is 5mA.
Input detection mode:
a. When VCC is 5V, DIGITAL IO is pulled up to 5V internally
through a 2.2K ohm resistor.
b. When VCC is 12V, DIGITAL IO is pulled up to 12V internally
through a 2.2K ohm resistor.
JPEG2000 AVoIP Encoder and Decoder
Bekijk gratis de handleiding van Vivolink VLVWIP2000-DEC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vivolink |
| Model | VLVWIP2000-DEC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1508 MB |
