Vivolink VLVWIP2000-DEC handleiding
Handleiding
Je bekijkt pagina 13 van 34
Operation description of the LED screen and CH SELECT buttons (For Encoder).
1, ENC ID: After the system is powered on, the Encoder’s LED screen will show the
ENC ID (000 by default if not set).
2, IP address: Press and hold the UP button for 5 seconds, the Encoder’s LED screen
will show in sequence “IPx", "xxx", "xxx", "xxx", "xxx", which are the IP mode and IP
address of Encoder.
3, Configuration mode: Press and hold UP + DOWN buttons at the same time for 5
seconds, then release to enter the configuration mode with “CFN” displaying on the
LED screen.
4, Device ID settings: After entering the configuration mode, press the UP/DOWN button
to enter the first page with the current ID number (e.g. 001) displaying on the LED
screen (000 by default). Press and hold UP + DOWN buttons for 5 seconds, then
release to enter the ID settings mode, in which the ID number (e.g. 001) on the LED
screen will flash at 1Hz, then press the UP/DOWN button to select the device ID you
desired (ID range: 000~762), then press and hold UP + DOWN buttons for 5 seconds
to confirm the setting and stop flashing. After setting, the unit will reboot automatically.
Note: The device ID can not be modified in Controller Box mode.
5, EDID settings: After entering the configuration mode, press the UP/DOWN button
to enter the second page with “E00” (in which “E” refers to EDID, “00” to EDID ID) or
“COP” (which indicates copy EDID) displaying on the LED screen (E15 by default).
Press and hold UP + DOWN buttons for 5 seconds, then release to enter the EDID
settings mode, in which the EDID ID number (e.g. E01) on the LED screen will flash
at 1Hz, then press the UP/DOWN button to select the EDID ID you desired, then press
and hold UP + DOWN buttons for 5 seconds to confirm the setting and stop flashing.
The corresponding EDID ID is as follows:
17
LAN (POE)
19
Link Signal
Indicator lamp
(Green)
▪ Light on: The network cable is connected normally.
▪ Light off: The network cable is not connected well.
7 / 27
18
Data Signal
Indicator lamp
(Yellow)
▪ Light flashing: There is data transmission.
▪ Light off: There is no data transmission.
20 DC 12V
The device can be powered via two methods:
▪ Local DC 12V/2.5A power supply
▪ POE from Network Switch. Device acts as PD mode.
When the Switch supports POE function, DC power supply
is not needed.
1G LAN port, connect network Switch to form a distributed
system.
Note: When network switch delivers POE power supply, DC
12V adapter doesn't need to apply on the unit.
JPEG2000 AVoIP Encoder and Decoder
Bekijk gratis de handleiding van Vivolink VLVWIP2000-DEC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vivolink |
| Model | VLVWIP2000-DEC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1508 MB |
