Vimar 01532 handleiding

Niet gecategoriseerd

Vimar

74 pagina's

PDF beschikbaar

Handleiding

BUILDING AUTOMATION

Shutter type (without louvers)

Fig. 4.15 Parameter window “Cx: Drive”

Parameter “Total travel time [20…50000]*0.1s”

This parameter sets the time required for the shutter to move the total stroke.

The total travel time is the time it takes for the blind to move from the highest position to the lowest position (as shown below). When the louver actuator

receives a command to move up or down, the louver moves according to the required direction until the louver receives a command to stop moving, or

until it moves to the highest or lowest position, then the louver passes through itself The limit switch turns the motor off. If the blinds are closed by the

motor, the corresponding output of the connected actuator is still closed and the output connection will only be disconnected if the set total travel time

has elapsed.

Shutter UP

Upper limit

switch

Lower limit

switch

Total travel

time

Shutter

DOWN

Note: The current position of the Shutter during operation can also be determined with the help of the total move time. It is therefore important

to measure and set the total move time as accurately as possible, particularly if the functions “Move to position via a 1 byte value” and “Status

response” are used. Only then is it possible to calculate the current position of the Shutter precisely.

Parameter “Delay time from switch-on to moving [0..200]*10ms”

This parameter sets the delay time for the Blinds/Shutter to start running, that is, after receiving the control command and closing the relay contact, how

much time delay is required before the curtain starts to slide, that is, the start buffer time of the motor. Options:

0..200

The setting of this parameter needs to be considered in conjunction with the starting technical characteristics of the curtain.

Parameter setting description in the ETS

Bekijk gratis de handleiding van Vimar 01532, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.