Handleiding
Je bekijkt pagina 25 van 84
EN-25
Viking | RVL Single/Double Wall Oven | MVSOE6301/MVDOE6301
Steam-Clean Function
The Steam-Clean feature is designed for light
oven cleaning.
1. Before starting the Steam-Clean cycle, make sure
oven is cool and the drip tray is in place below the
oven door. Remove the oven racks, rack supports,
and any other items/utensils from the oven.
2. Select Steam Clean icon.
3. For best results, pour 4 oz (118mL) of room
temperature distilled or filtered water onto the
oven bottom. Never pour cold water into a hot
oven, as doing so can cause the porcelain finish
to break and flake o. Do not add any type of
cleaner or additive to the water. Tap water may leave
mineral deposits.
4. Close the door(s) completely.
5. Press the Steam Clean icon and confirm this process
on the next screen.
• To cancel the Steam-Clean cycle, press the little "X" below the 20 minute count down.
• A complete Steam-Clean cycle will take a total of 20 minutes.
• Since the water in the oven bottom is hot and steam is being created, do not open the oven door during the
Steam-Clean cycle.
• At the end of the cycle, there is one long beep to signal that it has finished.
6. Remove all remaining water and debris in the bottom of the oven with a sponge or cloth.
7. Wipe any remaining moisture from the oven door interior and oven cavity.
8. Use a soft brush or nylon scrubber to wipe the oven interior. This may help with more stubborn stains.
9. If any soil remains, run a second Steam-Clean cycle to help loosen debris for easier removal.
10. Reinstall the rack supports and oven racks.
• Ensure the bent prong at the bottom back of the rack support is installed in the bottom hole in the oven cavity
back wall.
• Only finger tighten the rack support screw tops. Over tightening may make it very hard to unloosen the screw
tops again for the next steam clean.
• Ensure the TruGlide™ glide racks are properly reinstalled. Note that the rack slide is installed on to the rack
support; the oven rack does not sit on the rack support.
Remove oven rack and rack supports.
Ensure drip tray is in place.
Note: The bent prong is installed in the bottom hole.
To stop the Steam-Clean cycle:
• Press the little "X" below the 20 minute count down.
Overview of TruGlide™ glide rack installation. 1. Hook back side of slide
onto rack support.
2. Slide the rack slide onto
the rack support until it
fits between these two
fingers of the rack.
Bekijk gratis de handleiding van Viking MVSOE6301, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Viking |
| Model | MVSOE6301 |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 14044 MB |
