VigilLink VLDT-AP0808 handleiding
Handleiding
Je bekijkt pagina 7 van 39
- 5 / 37 -
If there is a red X at the top-right corner of this icon as the figure above shown, it means the
host computer have not connected with the audio processor yet. In such case, click this icon,
then a dialog box with a list of IP addresses of all connected devices will pop out, as the
following figure shown.
Step 5: Choose the audio processor’s IP address and click CONNECT, then the processor
will be connected with the host computer. After connection, the CONNECT & SETUP box
(see the figure below) will pop out. You may close it directly if no such operation is needed.
If the audio processor has been connected with the host computer successfully, the Network
icon will appear in a way as shown below.
In addition, the audio processor supports DHCP dynamic IP acquisition. When the audio
processor is connected, click the network icon in the upper left corner (as shown in the
above figure) to enter the “Connect & SETUP” window. Then click “SETUP” to enter the
network settings page “RESET IP & DEVICE NAME”, as shown in the following figure.
Select “dhcp” in the IP mode drop-down menu to select the dynamic DHCP mode. Then click
“OK” to use DHCP mode for the network.
Bekijk gratis de handleiding van VigilLink VLDT-AP0808, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | VigilLink |
| Model | VLDT-AP0808 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6379 MB |
