Vevor YY-F100-433 handleiding
Handleiding
Je bekijkt pagina 9 van 172
- 7 -
the receiver has entered standby mode.)
Note:
The setting button can be difficult to press with fingers alone. To press the
button, you can use a small object such as a paperclip or a ballpoint pen
tip.
3. Enter the ID number (1~98) through the keypad. (You can’t register 99.)
4. Press the CALL button after entering the number, and the receiver will
beep, flash and vibrate, which means that the pager is successfully
programmed with the desired ID number. And then press the CANCEL
button to stop it from beeping, flashing and vibrating.
5. After the programming, LED 2 and LED 3 go out, and LED 1 begins
flashing. (When LED 1 flashes, it means that the receiver has entered
standby mode.)
6. Place the pager ID card and its holder back onto the receiver.
SETTING THE CALLING MODE OF THE RECEIVER
1. Remove the pager number holder and the pager ID card.
2. Press the setting button to enter the setting mode.
3. Press the setting button until the number of LED lights that are on is in
accordance with the desired calling mode. (Please refer to the following
chart.)
4. Choose any calling mode and press the CANCEL button. (If the
CANCEL button is not pressed, the calling mode setting will be
automatically completed after a few seconds.)
5. Place the pager ID card and its holder back onto the receiver.
The number of
powered-on LED lights
0
1
2
3
4
5
Paging duration
40s
8s
16s
24s
32s
40s
Beep
NO
YES
Vibrate
YES
Flash
YES
Bekijk gratis de handleiding van Vevor YY-F100-433, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | YY-F100-433 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10796 MB |
