Vevor RB-25 handleiding
Handleiding
Je bekijkt pagina 17 van 224
- 16 -
6).please note the angle setting of “1 point” must be bigger than the “2
point”,or the machine can’t work.please see the below two pictures.
7).Fix the angle adjustor by moving to left and right accordingly.
8).Operator should work on the outside of the rebar’s bending direction.
9).Rebar will be bent to set angle when pressing the start switch or pedal
switch.
Attention: In order to work precisely, Pls set at point 1 when the bending
angle is large(90°), and set at point 2 when the bending angle is small
(135 °)
Note :
① follow the processing capacity while use the product is a must, surpass
the product easily lead to failure.
②operation gripping bending reinforced material should pay special
attention to safety incidents such as bumping fingers.
③ According to the different hardness of reinforced material, special
attention should be paid to the fracture which may lead to safety incidents
such as wounding.
④ Please do not operate until you confirm no person and object in the
reinforced bending radius.
⑤ the product is electrical functioning machinery. As encountered by the
rain or water leading to leakage, it must be covered with waterproof
membrane after use.
4.6 Movement
1.Move the bender after making sure the handle fixing bolt is tight.
2. Make sure the stationary ring bolt is fixed when transit or move the
bender.
3. Chains must be inserted into the safety pin to pretend the bender from
shaking or waving in the transit.
4.When move the bender by fixing handle,4 bolts can not loose or
damaged. Move the bender together by 4 handles.
5. Maintenance
5.1 Check and Change
Bekijk gratis de handleiding van Vevor RB-25, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | RB-25 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 22625 MB |
