Vevor NRB-25 handleiding
Handleiding
Je bekijkt pagina 8 van 96
- 6 -
The adjustable stopper function to maintain the rebar in tln cold weather ,
warm up unit for 30-60 seconds so that the hydraulic oil reaches the proper
viscosity. Pull trigger -switch to extend piston and release when it has
reached its full stroke, Repeat 15-20 times.
When bending for the first time, you can make a mark at the positioning
screw according to the bending angle, so that you can bend the same
angle next time.
POINTS OF ATTENTION
1.Do not cover air vents.
CARE: If events are covered,motor will overheat and may burn out.
2.If hydraulic oil exceeds 70.( (158.F) in temperature, power will drop.
Allow unit to cool before resuming operation.(Be particularly careful in
summer, when the aluminium pump case heats up quicker.)
3.If a drop in power is observed and motor is unusually hot, check
carbon-Brushes.
4.Pull the #14 part valve to make the bending piston return back totally
after each bending.
MAINTENANCE
CLEANIN
Cleaning bender every day,preferably immediately after use.
CAUTION: Wear gloves to protect hands from metal splinters.Do not use
an air-gun:blasting with air can cause metal filings and/or dust to get into
eyes and respiratory system.
1.Disconnect unit.
2.Wipe or brush away all dirt and metal filings.Pay particular attention to
the lower half of the piston, where dirt is more easily accumulated.
Oil-level check
As the bender is hydraulically operated,the oil-level must be checked at
frequent intervals,preferably every day.Failure to maintain the oil at the
proper level results in a drop in pressure and loss of bending power.
Bekijk gratis de handleiding van Vevor NRB-25, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | NRB-25 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7533 MB |
