Vevor NRB-25 handleiding
Handleiding
Je bekijkt pagina 7 van 96
- 5 -
INSTRUCTIONS
Caution: Indicates hazard that could result in minor personal injury and/or
product damage.
Care: Indicates hazard that will result in product damage.
Pre-use checks
1.Check oil level.
2.Check condition of bender blocks and tightness of bender block bolts.
3.Check that the power source is approciate to the bender
CARE: if voltage is too high,the motor will burn out.If the voltage is too
Low,insufficient power will be generated.Never use DC power.
4.Check that power supply is properly earthed.
CAUTION: Failure to earth power supply may result in electric shock to
operator.
5.Check that cord is undamaged and that plug is not loose.
If an extension cable is to be used,make sure that it is undamaged and that
it is the proper thickness for the length.See table below.
Cable length
110/115V
230V
Cable size (AWG)
Nomibal diameter
Up to 10m (33 ft )
16
1.0mm²
Up to 15m (50 ft )
14
1.25mm²
Up to 30m (100 ft )
10
1.5mm²
6.Before plugging in,make sure that the switch lock is OFF.
Warm-up
In cold weather,warm up unit for 30~60 seconds so that the hydraulic oil
reaches the proper viscosity.Pull trigger-switch to extend piston and
release when it has reached its full stroke.Repeat 15~20 times.
Stopper adjustment
Bekijk gratis de handleiding van Vevor NRB-25, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | NRB-25 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7533 MB |
