Vevor HMR1200 handleiding
Handleiding
Je bekijkt pagina 19 van 320
- 18 -
7.6 Blade Check
Before starting, check for worn or damaged blades. If one blade is worn out
while the others look new, this could be because of a blade pitch problem.
Refer to the maintenance section of this manual for instructions on the
blade pitch adjustment procedure. Replace any worn out blades.
7.7 SAFETY KILL SWITCHES
This power trowel has been equipped with a safety kill switch. Safety kill
switches should be tested every time the engine is started.
NOTE
NEVER! disable or disconnect the kill switch. It is provided for
operator safety. Injury may result if it is disabled, disconnected, or
improperly maintained.
7.8 HANDLE PRESS KILL SWITCH
Located on the main handle tube is a red switch (FIG. 5). The switching
mechanism of this switch should operate freely and should always be kept
in this condition. With the switch in the OFF position, the engine should not
start or run. The purpose of this switch is to stop the engine in a runaway
situation, (i.e.-the operator releasing the handle during operation).
FIG.5
DO NOT let the machine sit unused with the engine at high speed for an
extended period of time. It will cause premature belt wear or may destroy
the belt.
ALWAYS set the engine speed to idle when the hand clutch is disengaged.
Bekijk gratis de handleiding van Vevor HMR1200, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | HMR1200 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 59152 MB |
