Vevor GQ-100D handleiding
Handleiding
Je bekijkt pagina 13 van 275
- 12 -
6. Clean the debris on the head and cable, check whether the spring is wear or
damaged, if the spring is seriously distorted or worn, stop using the scrap
immediately; check the pin of the spring joint, if the spring is in danger of falling
into the pipe.
7. Check whether the dredging head edge is sharp, otherwise it is necessary to
replace the sharp dredging head of the dredging edge. If the dredging head is not
sharp, it will affect the dredging effect, resulting in spring distortion, knot, and even
fracture.
8. Lubricate the machine according to the operation manual, which can make the
normal use of the machine and prolong the service life of the machine.
9. Test the machine performance: connect to the power supply, Put the switch
knob to the FOR and REV gears to see if the machine can start properly, Place the
switch knob in the OFF gear, Whether the machine can stop turning, If normal start
and stop, Prove that the electrical part of the machine is normal, Place the switch
knob in the OFF gear; Pull the spring out of the spring bin beyond the fuselage,
Install the fuselage in the correct way in the operation manual, Press the clutch
handle, Pull the spring hard, The spring cannot pull out, Release the clutch handle
handle to bounce quickly; plug in, Place the switch in the CW position, Press the
clutch handle, Spring rotation, Place the switch knob in the OFF gear, The
machine stops turning, Then put the switch knob in the REV gear, Press the clutch
handle, The spring turns in the opposite direction, And the machine makes a pure
sound, Prostrate that the machine is operating properly, Otherwise the machine
has a problem, Need to repair
PAY ATTENTION TO:
A spring whose wear or damage, spring joint pin cannot bounce, can cause
serious injury or fall into the pipe in use.
1. The workplace should meet the following requirements:
Full lighting, no flammable and explosive gas, liquid, or dust.
The working area should be dry and the ground is flat. Do not support the
machine in the water area, and the operator should not stand in the water.
A socket with ground protection.
Clean up the area where the wire passes to ensure that there is no damage to
the wire, such as heat sources, grease, sharp objects, or other moving
Bekijk gratis de handleiding van Vevor GQ-100D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | GQ-100D |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 49458 MB |
