Vevor D1000 handleiding
Handleiding
Je bekijkt pagina 26 van 256
Belt removal / installation
1. Remove the belt protection cover, and do not use the dredging machine when
there is no cover cover.
2. With the hexagon wrench in the tool bag, remove the two hexagon screws fixed
on the square steel under the motor base, and press the motor vigorously. At this
time, the belt on the drum becomes loose and take the belt by hand.
3. Follow the opposite step and install a new belt.
Replace the spring
Replace the damaged or worn springs
Remove the spring from the drum
1. Pull the remaining cables out of the drum.
2. The machine is closed drum: there is a 70cm long short spring in the drum, the
main cable needs to loosen the screw connecting the long spring; the machine is
open drum: the screw fixing the end of the spring on the wall of the drum.
3. Remove all the springs (except the short springs) from the drum.
Install the new spring
1. In order to make the spring installation easy, completely untie the new spring
coil, to be careful to remove the packaging of the spring, the spring is elastic, may
hurt the operator;
2.The drum is closed: connecting the long spring directly to the short spring fixed
in the drum; the drum is open: piercing the spring through the hole of the
hat-shaped component.
3. Push the spring into the drum by hand (always with gloves fitted with the
machine).
The spring should be coiled in a counterclockwise direction.
The spring in the drum is coiled direction
Bekijk gratis de handleiding van Vevor D1000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | D1000 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 37740 MB |
