Vevor D1000 handleiding
Handleiding
Je bekijkt pagina 17 van 256
1 Remove the screw at the spring connector 2 insert the connector on the tool into
the spring connector 3 place the removed gasket and screw 4 Tscrew the installed
dredge head.
11. Place the foot moving switch, easy to operate, and also easy to operate the
CW / OFF / CCW switch.
12. Confirm that the CW / OFF / CCW switch is placed in the closed OFF position.
13. Plug the dredge machine plug into the socket, and the place of the wire has
been checked according to the above method. If it is not long enough, meet the
required wiring board can be used.
Use three plugs, see the previous electricity safety section.
Whether all electrical equipment components are intact.
The wires meet the standards for outdoor use, such as the "W" or "W-A" mark.
The wire has a sufficient diameter (16 AWG 50 ft, 14 AWG 50-100 ft). If too
small, the wire will overheat, melt the insulation and cause a fire.
The wiring board should also have the GFCI function. The GFCI function of the
machine does not protect the operator from the electric shock of the wiring board.
If the wiring board does not have GFCI function, then it is best to use a plug with
GFCI function in the middle to reduce the risk of electric shock.
Bekijk gratis de handleiding van Vevor D1000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | D1000 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 37740 MB |
