Vevor 3 IN 1/305 handleiding
Handleiding
Je bekijkt pagina 7 van 207
- 5 -
SET-UP AND ASSEMBLY
Floor Diagrams
Figure 1 – hole centers for Shear, Brake and Roll
Assembly
Tools required for setup and assembly:5, 6mm hex keys (“Allen
wrenches”)16mm open end wrench.
1. Take out machine and spare parts from box.
2. Carefully clean all rust protected surfaces with a mild solvent or
keroseneand a soft rag. Do not use lacquer thinner, paint thinner, or
gasoline, as these maydamage painted surfaces.
3. Coat all machined surfaces with a verylight film of oil to inhibit rust.
4. Carefully move machine to a workbench or stand. Machine location
must allow free access on all sides.
5. Bolt machine to stand or workbench. The stand or workbench must be
bolted to the floor. (NOTE: An optional stand is available for this machine;
see Section 8. Contact KAKA distributor to order.)
Bekijk gratis de handleiding van Vevor 3 IN 1/305, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | 3 IN 1/305 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 24980 MB |
