Vevor 28104-1 handleiding
Handleiding
Je bekijkt pagina 32 van 288
- 30 -
CUTTING THE SECOND WORKPIECE
NOTE:
If the thickness is different between the first and second
workpiece, replace the scrap piece in the upper clamp
(horizontal Mounting position) with another that is the same
thickness as the first workpiece.
Step 1 - Use the wrench (A) Fig. S8 to loosen the screw on the right
offset guide (B) Fig.S10. Move the guide to the far right.
Step 2 - Clamp the first board in the lower clamp on the right side of
the jig with the fingers protruding past the template (Fig.
S9).Center the protrusions of the wood in between the
fingers of the templet.
Step 3 - Move the right offset guide flush against the workpiece
and secure it with the w r e n c h (Fig. S10).
Step 4 -
Remove the first workpiece.
Bekijk gratis de handleiding van Vevor 28104-1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | 28104-1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 74655 MB |
