Vevor 28104-1 handleiding
Handleiding
Je bekijkt pagina 16 van 288
- 14 -
TEAROUT REDUCTION
Tearout is unwanted splintering of the wood fibers that occurs when a
router bit enters, exits, or skims the edge of wood and is common to
all dovetail jigs. Tearout cannot be eliminated, but it can be reduced by
the insertion of additional scrap wood against the workpiece.
ALIGNING THE TEMPLATES
For proper operation, you must align the templates correctly from front
to back. The 28104 series jigs have alignment lines to help you align
the templates without measuring. Some templates have one line (Fig.
H1) while others have several lines to produce multiple types of
joints (Fig. H2). VEVOR has scribed icons on the templates to
indicate which lines go with which joints.
Adjust the templates front-to-back until the alignment line is directly
over the point where the horizontal board and the vertical board meet.
NOTE: To be accurate, lean over the template and look straight down to
align the lines (Fig. H3).
For the joint to be produced correctly, loosen the knobs on both
sides of the template, align the lines, hold the template flat with one
hand, and tighten the knobs with the other (Fig. H4).
NOTE: To help align both ends of the template when you are using a
narrow workpiece, mount an additional piece
of wood (of the same thickness) on the far right (A) Fig. H5.
Bekijk gratis de handleiding van Vevor 28104-1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | 28104-1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 74655 MB |
