Vevor 28104-1 handleiding
Handleiding
Je bekijkt pagina 12 van 288
- 10 -
ADDITIONAL TOOLS REQUIRED
The router that you use with this jig
must accept the VEVOR template guides supplied
with the jig. (Adapters and sub-bases are available for
most routers.)
must have a 1/2" collet for use with 28104-3 jigs
.
must have a 1/4" collet for use with
28104-1 jigs
.
NOTE: While the jigs and accessory kits include the
router bits and template guides to make the basic dovetail joints,
additional router bits are required to make box joints.
MOUNTING INSTRUCTIONS
NOTE: Always mount your jig to a solid work surface.
You can mount your jig permanently (Fig. B1) by using the pre-drilled
holes (A) Fig B1) on each side of the base, or you can mount the base
to your work surface using clamps (Fig. B2).
OPERATION
Mount your workpiece in the jig properly. If the workpiece is not secure,
it can be damaged when it moves.
The jigs utilize two mounting positions for workpieces - horizontal
and vertical. Some joints require both, while others require the use
of a scrap board in the horizontal position (upper clamp) and the
workpiece in the vertical position (lower clamp).
Position your workpiece correctly left-to-right to produce symmetrical
and tight-fitting joints.
Tear-out from the router bit can be reduced when scrap wood is
positioned properly against the workpie
Bekijk gratis de handleiding van Vevor 28104-1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | 28104-1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 74655 MB |
