Vevor 234-2-31 handleiding
Handleiding
Je bekijkt pagina 14 van 128
6. Tighten the set screws.
Tighten each set screw until it contacts the torsion tube. Tightening the screws
more than this could distort or puncture the torsion tube, so be sure to make less
than 1 full rotation once the screws touch the torsion tube.
7. Remove the clamps or pliers.
It is now safe to remove the clamps or pliers you used to hold both the
torsion bar and the garage door itself in place.
Note: When to add or unwind 1 or 2 quarter turn , must be hold on the
clamps or pliers again.
8. Check the balance after installed.
Leave the door at half way position:
If the door moves up on itself, means torsion spring are wound too much,
in this case, to unwind both of the torsion spring 1 or 2 quarter turn until
the door balance itself.
Bekijk gratis de handleiding van Vevor 234-2-31, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | 234-2-31 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 28308 MB |
