Vevor 234-2-31 handleiding
Handleiding
Je bekijkt pagina 12 van 128
2. Install the center bearing and the right spring, then secure the cones.
Slide the torsion bar to the left then add the center bearing. Slide the right spring
onto the bar and press the bearing into the stationary cone. Connect both of the
stationary cones to the center bracket with the nuts and bolts you removed
previously. Remove the locking pliers or clamp from the center bracket.
3.Thread the cables and tighten the drums.
Run the lift cable between the roller and the doorjamb. Slip the lift cable stop
through the cable slot on the drum. Then attach locking pliers to the torsion tube
to secure it in place. Spin the drum to wind the cable into the grooves, then tighten
the set screws. Repeat on the other side, leaving the locking pliers in place.
Note: For the door to operate properly, you need the same amount of tension on
both sides, so take care to tighten each side evenly.
Bekijk gratis de handleiding van Vevor 234-2-31, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | 234-2-31 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 28308 MB |
