Vestil WP-3648 handleiding
Handleiding
Je bekijkt pagina 11 van 17
Table of Contents Rev. 4/12/2024 WP, MANUAL
Table of Contents Copyright 2023 Vestil Manufacturing Co. Page 11 of 17
(Continued from p. 10)
DO NOT drive the fork truck while the platform is occupied. Fully lower the platform and allow all platform
occupants to dismount before driving the forklift.
Set the parking brake before lifting the platform.
Occupants must hold onto the handrail on two sides of the work platform whenever it is ascending or descending.
If the platform is equipped with (optional) casters, DO NOT move the platform if it is occupied. Require all persons to
get off of the platform AND unload the platform completely BEFORE moving it.
Before anyone occupies the work platform, confirm that the safety strap is attached to the fork carriage without slack.
Perform a BEFORE EACH USE inspection. Inspection procedures are provided on p. 6. Never exit the guardrail
enclosure while a work platform is elevated.
Model WP Platforms: Push open the gate(s) to enter the work platform. Release the gate once you are inside the
guardrail. All gates should automatically return to the closed position. If all gates operate normally, then attach your
lanyard to one of the anchor points. Anchor points are shown in the USING THE PLATFORM diagrams on p. 10. DO
NOT elevate the platform until you have attached your lanyard to an anchor point.
Model SP-175: Open a gate and enter the platform. Latch
both of the safety chains to their D-links. Attach your
lanyard to one of the anchor points. Anchor points are
identified in the diagram. The fork tubes in front of the
occupant enclosure support a loaded or unloaded
skid/pallet. Orient the elevated platform with the side of
the platform adjacent (in front of) the loading bay.
Model WP-3737-FD: Enter the platform from either side. Lift the gate, pull the gate fully closed, and then press the gate
down to secure the latch. See WP-3737-FD SETUP/FOLD-DOWN INSTRUCTIONS. Attach your lanyard to the lanyard
anchor point which is identified in STEP 3 “Raise the front guard rail” on p. 12. Confirm that both gates are securely
latched before elevating the platform.
WP-3737-FD SETUP / FOLD-DOWN INSTRUCTIONS
NOTE: Folding the platform creates pinch points. Keep feet, hands and clothing away from pinch points while folding or
setting up the work platform.
Step 1: Identify the pegs (welded to the inside of the
toeboard and the slots (at the bottoms of the guardrail posts)
as shown below.
Step 2: Raise the mast guard.
Lift the guard to allow the pegs to fit into the
slots.
Peg
Slot
Nylon
safety
strap
Anchor
points
Attach
lanyard
Bekijk gratis de handleiding van Vestil WP-3648, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | WP-3648 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8273 MB |
