Vestil WL-100-5-810 handleiding
Handleiding
Je bekijkt pagina 25 van 30
Operator’s Manual Rev. 6/11/25 WL-100 MANUAL 06-25.DOCX
Table of Contents Copyright 2023, Vestil Manufacturing Corp. Page 25 of 30
INSPECTION AND MAINTENANCE
Proper maintenance is essential for maximizing the service life of this product. If an inspection reveals any
irregularities in the Dock Lift’s condition, repair it before returning it to service. Only use manufacturer-approved
replacement parts. Contact Technical Service if you have questions that are not addressed in these instructions or if you
are uncertain how to address an issue discovered during an inspection. Technical Service can be contacted by calling
(260) 665-7586 and asking for the Service and Parts Department or by submitting questions online at
http://www.vestilmfg.com/parts_info.htm.
Care should be taken to identify all potential hazards and comply with applicable safety procedures
before beginning work.
Remove any load and install the maintenance props before beginning any inspection or service on
the Lift. See below.
Only qualified individuals trained to understand mechanical devices, electrical and hydraulic circuits, and the hazards
associated with them, should attempt troubleshooting and repair of this equipment.
Inspection procedures.
Prior to performing any inspection or maintenance on this Lift:
Read and understand these maintenance procedures.
Remove the load from the platform. Do not attempt to service a loaded Dock Lift.
Fully lower the platform, OR use both maintenance props to support the weight of the platform. To use the
maintenance props, raise the platform to its full height. Rotate both props over to the inside of the frame rail (or
place the drop-in props in front of the rollers, against the front edge of the base). Lower the platform until the
rollers roll up against the props.
Disconnect power. Follow established lockout/tagout policies as required.
Initial inspection.
Prior to use, any new, altered, modified, or repaired Scissor Dock Lift shall be inspected by a qualified person.
Complete both the daily and monthly inspection items before releasing the Lift for regular use.
Daily inspection.
At the beginning of every shift, a designated person shall complete these inspections. Remove the lift table from
service and repair or replace any damaged parts if any of the following is found.
1. Look for:
a. Frayed wires.
b. Oil leaks.
c. Pinched, chafed, worn, or cracking hydraulic hoses.
d. Damage, deformation, or cracks in any structural member or any weld. Give special attention to the
hydraulic cylinder mounting brackets.
e. Loose or missing fasteners.
f. Unusual noise or evidence of binding.
2. Test the function of the upper travel limit switch and the perimeter toe guard.
Bekijk gratis de handleiding van Vestil WL-100-5-810, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | WL-100-5-810 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8817 MB |
