Vestil VSSR-15 handleiding
Handleiding
Je bekijkt pagina 5 van 7
Table of Contents Rev. 4/13/2021 VSSR, MANUAL
Table of Contents Copyright 2021 Vestil Manufacturing Corp. Page 5 of 7
INSPECTIONS & MAINTENANCE
NOTICE
Regular use, maintenance, and storage are essential for this product to function properly for as long as
possible.
o Use this product only as instructed in this manual.
o Keep the product clean & dry.
Compare inspection results to the RECORD. Do not continue using the rack unless it is in
SATISFACTORY CONDITION. DON’T GUESS! If you have any questions about the condition of your VSSR-
15, contact the TECHNICAL SERVICE department. The phone number is provided on the cover page of
this manual. Never make temporary repairs of damaged or missing parts. Cosmetic changes, like
damaged paint/powder coat are changes from satisfactory condition. However, touchup paint should
be applied to all affected areas as soon as damage occurs. Exposed metal rusts. Rusting could
degrade the structural integrity of the metal if rusting becomes significant.
Inspect the following at least once per month:
1. Surfaces – Check all surfaces of the rack for dirt or other matter and water or other fluids. Clean all
surfaces. Examine the whole structure for rusting, metal erosion, rot, or thinned regions. In particular,
examine the areas around bolt holes for rusting and corrosion. If rusting is purely superficial, remove it.
Clean the affected area and apply touchup paint. If rusting, rot, or thinning has weakened the
material, contact TECHNICAL SERVICE
for advice.
2. Anchor bolts & wall fasteners – Examine each of the anchor bolts and wall fasteners (if applicable)
for corrosion, rusting, wear, and other damage. Each bolt should be solidly fastened to the floor.
Each wall fastener must be tight. Tighten loose bolts and wall fasteners. The rack must be solidly
attached to the floor and must not wobble. Replace fasteners, bolts, and anchors as necessary.
3. Dividers – Measure distances between dividers. Measure distances in the same places as the
measurements taken in the RECORD
. Confirm that distances are unchanged. Examine welds at the
base of each leg of each divider. Each divider must be solidly welded to the base frame. Welds must
not be rusted, cracked, or otherwise degraded. Dividers must not be cracked, deformed, or loose.
4. Labels – Replace missing and/or damaged labels. All labels should be easily readable from a
reasonable distance.
Bekijk gratis de handleiding van Vestil VSSR-15, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | VSSR-15 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1239 MB |
